2.SETTING ITEMS (ADMIN)
IEEE 802.1X Authentication Setting 205
2 SETTING ITEMS (ADMIN)
Setting EAP-TLS
The CA certificate and user certificate must be installed in this equipment before the settings for IEEE 802.1X
authentication are performed. For instructions on how to install the certificates, refer to the TopAccess Guide
“Chapter 8: [Administration] Tab Page”.
1
Select [EAP-TLS] and press [Next].
The WIRED 802.1X SETTINGS (EAP-TLS) screen is displayed.
2
Specify the following items as required and press [Next].
[EAP USER NAME] — Press this button to enter the EAP User name.
Use Username from Common Name in the User Certificate — Press [ENABLE] to use a common name in the
user certificate as the EAP User name.
When you enable the [Use Username from Common Name in the User Certificate] option, any user name
cannot be manually entered to the [EAP USER NAME] box.
When you press [EAP USER NAME], the on-screen keyboard is displayed. Enter the value using the on-screen
keyboard and press [OK] to set the entry. You can also use the digital keys on the control panel to enter
numerals.
To Next Page
Loading...
Need help?
General
