e-STUDIO520/523/600/603/720/723/850/853 © 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
TROUBLESHOOTING
5 - 94
[CDE0] Paddle unit home position error detection [MJ-1029]
[CF00] Belt escape unit home position error detection [MJ-1029]
Check the paddle home position sensor (PI26). Does the sensor operate normally?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and paddle motor (M14) normal?
NO Repair the wiring.
YES
Is there any abnormality in the paddle mechanism?
NO Check the assembly and repair the paddle mechanism.
YES
Does it improve when the paddle motor (M14) is replaced?
NO Replace the finisher controller PC board.
YES
End
Check the Knurled belt home position sensor (PI28). Does the sensor operate normally?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and Knurled belt motor (M13) normal?
NO Repair the wiring.
YES
Is there any abnormality in the belt escape mechanism?
NO Check the assembly and repair the mechanism.
YES
Does it improve when the Knurled belt motor (M13) is replaced?
NO Replace the finisher controller PC board.
YES
End
06/10
To Next Page
Loading...
