Toshiba ER-LD430C - Desired Temperature Heating: Basic Steps; Setting Temperature and Starting

40
Adjustment of temperature
Desired temperature heating
◆Quantity for one person (150g) is considered as standard.
Place the food into the chamber.
・Please use the container for microwave depending on the quantity of food,
Place the food in the center of the oven chamber.
1
4
2
3
Press to start
Heating start
The buzzer will beep 3 times when finish.
・If you forgot to take the food out, the buzzer will beep 5 times in an interval of one minute.The beep will
stop on press [Cancel] and open the door.
Rotate and select temperature from ー10〜90℃
・Refer from table on right side for approximate temperature setting.
Press 6 times to select [DESIRED TEMP]
※
■For further heating, once cooking is complete. [EXTENSION]
→ This is done by rotating the dial to set the time within 1 minute after the completion of cooking and the process has to be monitored.
■Ensure inside the oven chamber is cooled before start cooking.
・If the oven is hot, infrared sensor will not work properly.
■Food is placed at the centre with the circle as the standard
Example : Soften the butter
Displaysremainingtimefromthemiddle.
Accessories
cannot be used
On pressing, it is the cycle change to
600W
STEW
DESIREDTEMP
500W 200W 100W 900W
※