Toshiba ER-LD430C - Convection Cooking with Preheat; Starting Preheat and Cooking

42
Adjustment of time and temperature
Convection cooking
The temperature is adjusted by rotating
・Set temperature：100〜300℃ , 350℃
When machine is hot（ Display part will show「 HIGH TEMP」 with blinking light）,
since an electric preventive device can not be set over 260℃ .
Press to start preheat.
Display shows the remaining time 1 min.
before preheat finish.
The buzzer beeps 5 times and [PREHEAT FINISH] will showing on the display part.
4
Once preheating is completed, the food is placed inside the oven and the timing is adjusted by rotating
・Maximum time：90 min
・When you want to change the cooking temperature to a temperature that is different from the temperature
used for preheating, press
after adjusting the time,
the temperature can be increased or decreased in steps of 10℃ by rotating
with preheat
without preheat
With preheat
3
Remainingtime
1
Press once with the oven empty.
※
is displayed in the display unit
2
There are some menus that require preheating to be done with the square tray in the oven.
Follow the instructions given in the separate cuisine booklet.
CONVECTION（withpreheat）
CONVECTION（withoutpreheat）
GRILL
FERMENTSTEAMFERMENT
On pressing, it is the cycle change to
※
・ Since the square tray will be hot, be careful
when you add or remove food.
・ Preheat will last approximately for 20 min.
If nothing is done in this duration, preheating will be completed.
Heating start
The buzzer will beep 3 times when finish.
・If you forgot to take the food out, the buzzer will beep 5 times in an interval of one minute.
The beep will stop on press [Cancel] and open the door.
・LCD displays [HIGH TEMP]
・As the oven body and square tray are hot, please hold with care when remove.
5
Press