Toshiba MD13N3 - Page 18

DISASSEMBLY INSTRUCTIONS
B2-3
2-8: RELAY PCB ASS'Y (Refer to Fig. 2-8-A)
Remove the screw 1.
Remove the Relay PCB Ass'y.
1.
2.
Fig. 2-8-A
1
Relay PCB Ass'y
Main Chassis Ass'y
NOTE
1. When installing the wire of the Relay PCB, install it
correctly as Fig. 2-8-B.
• Screw Torque: 4 ± 0.5kgf•cm
Fig. 2-7-B
Fig. 2-7-C
Should not be engaged.
Check the position of
the Rack Feed Lever.
Moving smoothly
Moving smoothly
Fig. 2-8-B
2-10: IDLER ARM (Refer to Fig. 2-10-A)
Remove the Idler Arm Spring.
Remove the Chassis Spring.
Remove the Idler Arm.
1.
2.
3.
Fig. 2-10-A
Idler Arm
Idler Arm Spring
Chassis Spring
Main Chassis Ass'y
NOTE
1.
2.
In case of the Idler Gear installation, install correctly as
Fig. 2-9-B.
When installing the Middle Gear 2, check if the Middle
Gear 2 is locked correctly as Fig. 2-9-C.
Fig. 2-9-B
[OK] [NG]
Idler Gear
Idler Gear
Idler Arm Idler Arm
Fig. 2-9-C
Middle Gear 2
Check Lock
2-9: GEAR (Refer to Fig. 2-9-A)
Unlock the support 1.
Remove the Middle Gear 1/2/3, Idler Gear and Feed Gear.
1.
2.
Middle Gear 1
Middle Gear 2
Middle Gear 3
Idler Gear
Feed Gear
Fig. 2-9-A
1
Main Chassis Ass'y