Toshiba MD13N3 - V-Chip Parental Control Setup; Registering V-Chip Password

DISASSEMBLY INSTRUCTIONS
B2-4
Idler Arm
Main Chassis Ass'y
Fig. 2-10-B
Fig. 2-10-C
Fig. 2-10-D
Chassis Spring
Main Chassis Ass'y
NOTE
1.
2.
3.
In case of the Idler Arm installation, install as the circled
section of Fig. 2-10-B.
In case of the Idler Arm Spring installation, install as the
circled section of Fig. 2-10-C.
In case of the Chassis Spring installation, install as the
circled section of Fig. 2-10-D.
Idler Arm Spring
Main Chassis Ass'y
Fig. 2-11-A
• Screw Torque: 1 ± 0.5kgf•cm
2-11: FEED MOTOR (Refer to Fig. 2-11-A)
Remove the 2 screws 1.
Remove the Feed Motor.
Remove the Motor Gear.
1.
2.
3.
1
1
Motor Gear
Feed Motor
Main Chassis Ass'y
NOTE
1.
2.
In case of the Motor Gear installation, check if the value
of the Fig. 2-11-B is correct.
When installing the Feed Motor, check if the cable is
positioned as Fig. 2-11-C.
Fig. 2-11-B
6.1 ± 0.1mm
Safety surface for pressing
of the insert.
Feed Motor
Motor Gear
Fig. 2-11-C
Main Chassis Ass'y
Feed Motor
Pass the cable
between 2 pins.