79
7. OUTDOOR UNIT INSTALLATION
7-1. Selecting a Location for Installation
CAUTION
Check that it is installed at a place where flammable gas does not leak.
If gas leaks and accumulates on surroundings of the unit, combustion may be caused.
Check that the outdoor unit is fixed to the base.
Otherwise, an accident such as falling may be caused.
REQUIREMENT
• Avoid a location where a machine is generating high frequency.
• Using the air conditioner at a specific location where spray of oil (including machine oil) or steam is
possible, salty location such as seaside, or place where gas sulfide generates such as hot spring may
cause a trouble.
If doing so, a special maintenance is required. For details, contact the dealer which you purchased it.
• Avoid obstruction of inlet port and outlet port of the outdoor unit so there is no restriction of air flow.
• Avoid to installing the air conditioner in a location where strong wind blows against the inlet or outlet port of
the outdoor unit.
• When using the air conditioner at the snow area, mount a snowfall frame or hood to the outdoor unit.
For details, contact the dealer which you purchased the air conditioner.
• Drain water from the outdoor unit to a place having good drainage.
• Set TV or radio 1m or more apart from the main unit of air conditioner or remote controller.
Quality of picture or noise may be affected.
Attention to operation sound
• Select a location with sufficient strength, where operation sound or vibration does not transmit to other entities,
or does not increase.
• If an obstacle is put on the near outlet port of the outdoor unit, operation sound may increase.
• Select a position where neighbors are not affected by discharge air from the discharge port of the outdoor unit
or the operation sound.
Electric wiring
WARNING
Check that earthing practice is correctly performed.
Grounding is necessary. If earthing practice is incomplete, an electric shock may be caused.
CAUTION
Check the electrical leakage breaker is fitted.
It is necessary to fit an electrical leakage breaker. Otherwise, an electric shock may be caused.
Only use fuses with the correct capacity.
Using wire or copper wire may cause a fire or trouble.
For the power source, use a circuit with rated voltage exclusive for air conditioner.
To Next Page
Loading...
Need help?
General
