Toshiba MMW-UP0271LQ-E - Page 28

– 28 –
<Line (system) address>
2 Push the TEMP. / buttons repeatedly to set the CODE No. to
1212
1212
12.
3 Push the TIME / buttons repeatedly to set a system address.
(Match the address with the address on the interface P.C. board of the header outdoor unit in the same
refrigerant line.)
4 Push button.
(It is OK if the display turns on.)
<Indoor unit address>
5 Push the TEMP. / buttons repeatedly to set the CODE No. to
1313
1313
13.
6 Push the TIME / buttons repeatedly to set an indoor unit address.
7 Push the button.
(It is OK if the display turns on.)
<Group address>
8 Push the TEMP. / buttons repeatedly to set the CODE No. to
1414
1414
14.
9 Push the TIME / buttons repeatedly to set a group address. If the indoor unit is
individual, set the address to
00000000
00000000
0000 ; header unit,
00010001
00010001
0001 ; follower unit,
00020002
00020002
0002 .
10 Push the button.
(It is OK if the display turns on.)
11 Push the button.
The address setting is complete.
(
SETING
flashes. You can control the unit after
SETING
has disappeared.)
<RBC-ASCU11


>
1 Push and hold the [menu + ] buttons at same time for more than 10 seconds.
2 Push the [OFF timer] button to confirm the selected indoor unit.
<Line (system) address>
3 Push the [menu] button until the CODE No. flashes. And using the [ or ] buttons,
specify the CODE No.12.
4 Push the [menu] button until the SET DATA flashes. And using the [ or ] buttons, set
a system address.
5 Push the [OFF timer] button to confirm the SET DATA.
2
3,4
3,4
3,4
6
2,5