Toshiba MMW-UP0271LQ-E - Method to Set Hot Water Module Function DN Code

– 23 –
8-4. Method to set hot water module function DN code
(When performing this task, be sure to use a wired remote controller.)
Procedure
Be sure to stop the air conditioner before making settings
<RBC-AMT


>
1 Push the + + buttons simultaneously and hold for
at least 4 seconds.
The unit No. displayed first is the address of the header indoor unit
(including Hot Water Module) in group control.
2 Each time the “Select unit” side of the
UNIT LOUVER
button (left
side of the button) is pushed, one of the indoor unit
(including Hot Water Module) No. under group control is
displayed in turn.
3 Use the button to select the CODE No. (DN code) of
the desired function.
4 Use the button to select the desired SET DATA
associated with the selected function.
5 Push the button. (The display changes from flashing to steady.)
• To change the selected hot water module, go back to step 2.
• To change the selected function, go back to step 3.
6 When the button is pushed, the system returns to normal off state.
<RBC-ASCU11


>
1 Push and hold menu button and [ ] setting button simultaneously for 10 seconds or more.
• After a while, the display flashes as shown in the figure. “ALL” is displayed as indoor unit numbers during
initial communication immediately after the power has been turned on.
2 Each time [ ] [ ] setting button is pushed, indoor unit numbers in the group control
change cyclically. Select the indoor unit to change settings for.
• The fan of the selected indoor unit runs . The indoor unit can be confirmed for which to change settings.
3,6
4,5 1 7
2,4,
5
Indoor unit No.