– 24 –
4 Push the menu button to make Code No. [
] flash. Change Code No. [
] with [ ]
[
] setting button.
5 Push the menu button to make Set data [
] flash. Change Set data [
] with
[
] [ ] setting button.
6 Push OFF timer button to complete the set up.
• To change other settings of the selected indoor unit, repeat from Procedure 4.
7 When all the settings have been completed, push ON/OFF button to finish the settings.
(Return to the normal mode)
“
SETTING
“ flashes and then the display content disappears and the air conditioner enters the normal stop
mode. (The remote controller is unavailable while “
SETTING
“ is flashing.)
• To change settings of another indoor unit, repeat from Procedure 1.
3 Push OFF timer button to confirm the selected indoor unit.
NOTE:
In case of the hot water module, remove the front panel so that P.C. board is visible and then check the
D02 LED at the center of P.C. board goes on to judge whether DN is being set or not.
The LED goes on while DN code is being set.
Set data
Code No.
To Next Page
Loading...
