– 34 –
NOTE: The LED on the P.C. board of the selected hot water module flashes. The hot water module for change
settings can be confirmed.
<RBC-ASCU11
>
1 Push and hold the [menu + ] buttons at same time for more than 10 seconds.
2 Push the [OFF timer] button to confirm the selected indoor unit.
3 Push the [menu] button until the CODE No. flashes. And using the [ or ] buttons,
specify the CODE No.13.
4 Push the [menu] button until the SET DATA flashes. And using the [ or ] buttons, set
an indoor unit address.
5 Push the [OFF timer] button to confirm the SET DATA.
6 When all the settings have been completed, push the [ON/OFF] button, return to normal
mode.
2
3, 4
3, 42, 5
16
3, 4
To Next Page
Loading...
