– 36 –
4 Push the TIME / buttons repeatedly to change the value of the indoor unit address in
SET DATA.
Change the value in SET DATA to that of a new address.
5 Push the button to confirm the new address on SET DATA.
6 Push the
UNIT LOUVER
button (left side of the button) repeatedly to select another address to
change.
Each time you push the button, the indoor unit numbers in a refrigerant line are indicated
one after another. Only the fan and louvers of the selected indoor unit are activated.
Repeat steps 4 to 6 to change the indoor unit addresses so as to make each of them unique.
7 Push the button.
(All the segments on the LCD display light up.)
8 Push the button to finish the procedure.
NOTE:
The LED on the P.C. board of the selected hot water module flashes. The hot water module for change
settings can be confirmed.
<RBC-ASCU11
>
There is no such function in the remote controller.
SET
TIME
TIMER SET
TEST
FILTER
RESET
CL
FAN
SAVE
SWING/FIX
VENT
MODE
ON / OFF
UNIT LOUVER
4
6
8
5, 7
Press to finish setting
TEMP.
CODE NO.
Finish
To Next Page
Loading...
