Need help?Do you have a question about the Toshiba MV13M2 and is the answer not in the manual?
General| Brand | Toshiba |
|---|---|
| Model | MV13M2 |
| Category | TV VCR Combo |
| Screen Size | 13 inches |
| Screen Type | CRT |
| Tuner | NTSC |
| Remote Control | Yes |
| Inputs | Composite |
Warning about high voltage parts inside the equipment.
Emphasizes using parts with specific safety characteristics for replacements.
Guidance on repairing high voltage peripheral circuits to prevent X-ray emission.
Procedures for ensuring safety after repairs, including insulation checks.
Instructions for safely removing the CRT PCB, including discharge precautions.
Steps for removing the deck chassis and the Syscon PCB.
Detailed steps for removing various deck parts like brackets, cassette holder, and link units.
Procedures for removing the loading motor, worm, tension assembly, and related parts.
Instructions for removing the T brake arm, band, S/T reels, and idler arm assembly.
Steps for removing the cassette opener, pinch roller block, P5 arm, and A/C head.
Instructions for removing the capstan DD unit, main cam, and pinch roller cam.
Procedures for removing the clutch assembly, levers, gears, and cassette guide post.
Detailed steps for safely removing and installing the anode cap, including discharge.
Instructions for removing a flat package IC using desoldering equipment.
Steps for correctly installing a flat package IC, including soldering and checks.
List of available service modes and their corresponding operations.
Steps to ensure correct data settings when replacing the EEPROM IC.
Procedures for confirming and adjusting reel disk height and tension post position.
Steps to confirm playback and back tension torque using a torque tape.
Procedures for confirming VSR and reel brake torque for S and T reels.
Steps to confirm and adjust the audio/control head for optimal performance.
Adjustment procedures for the VCR section, including PG shifter and VCO freerunning.
Procedures for adjusting RF AGC, constant voltage, cut off, and white balance.
Adjustments for focus, horizontal phase, vertical parameters, brightness, and contrast.
Initial steps for static convergence using magnets and deflection yoke.
Procedures for adjusting purity magnets to center colors on the screen.
Fine-tuning static convergence using pole magnets.
Steps for performing dynamic convergence adjustments using wedges.
To Next Page
