Toshiba MW20FM1 - Connections; Antenna Connections

@tenna connections
If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your antenna system.
If you are using a cable TV service (CATV), see page 15 for Cable TV connections.
r
75 ohm
Coaxial
Cable
Antenna
Jack
Antenna
Jack
300-75 ohm
Matching
Transformer
Connect the 75 ohm Cable from the Combination VHF/UHF
Antenna to the Antenna Jack.
If your Combination VHF/UHF Antenna has a 300 ohm
Twin-lead Wire, the use of the 300-75 ohm Matching
Transformer may be necessary.
f.-
Antenna 300-75 ohm
Jack Matching
_,,_ _ Transformer
Combiner_ _
UHF 300 ohm
VHF 300 ohm
Connect the UHF 300 ohm Twin-lead Wire to the
Combiner (not supplied). Connect the VHF 300 ohm
Twin-lead Wire to the 300-75 ohm Matching Trans-
former. Attach the Transformer to the Combiner, then
attach the Combiner to the Antenna Jack.
Antenna
Jack
_,_ VHF 75 ohm
Combiner [m_(_ _
UHF 300 oh
Connect the VHF 75 ohm cable and UHF 300 ohm Twin-
lead Wire to the Combiner (not supplied). Attach the
Combiner to the Antenna Jack.
114