Toshiba MW20FM1 - Playing a Disc

_ _iii_i__i_ _ i,_ _i
PLAY
STOP
PAUSE/STILL
• To obtain a higher quality picture
Occasionally,some picturenoisenot usuallyvisibleduringa normalbroadcast
may appear onthe TV screen while playinga DVD video disc because the high
resolutionpicturesonthese discsinclude a lotof information.While the amountof
noisedepends on the unit,you shouldgenerally reduce the sharpnessadjustment
on the unit.
About _<_
The <_<_<:_> icons on the heading bar show the playable discs for the
function described under that heading.
<_ : You can use this function with DVD video discs.
: You can use this function with VIDEO CDs.
<3_> : You can use this function with audio CDs.
• To pause playback (still mode)
Press PAUSE/STILL duringplayback.
.PAUSE/STILL
To resume normal playback, press
PLAY.
• The sound is muted during still
mode.
• To stop playback
PressSTOP.
• To remove the disc
Press OPEN/CLOSE.
OPEN/CLOSE
Remove the disc after the disc tray
opens completely.
Be sure to press OPEN/CLOSE to close the disc tray
after you remove the disc.
• About the screen saver
Ifyou pause a picture ofa DVD videodisc and leave it
stillfor a long while,the screen saver of the unit
automaticallyappears (when "Screen Saver"isset to
"On" _). Toturn off the screensaver, press PLAY.
• Playing a Disc while the VCR section is recording or
standing by for timer recording
t) Start to record.
Follow step 1_5 on page 40.
• If the unit is standing by for recording, turn on the unit.
2) Press DVD to select DVD mode.
3) Play a disc.
Follow step 2 - step 5 on page 48.
• Press PLAY if the unit does not start to play a disc
automatically.
4) Stop to play
Press STOP to stop play back a disc.
_o
-o
==-
o
Notes:
• Do not move the unit during playback. Doing so may damage the disc.
• Use the OPEN/CLOSE button to open and close the disc tray. Do not push the disc tray while it is moving. Doing so may
cause the unit to malfunction.
• Do not push up on the disc tray or put any objects other than discs on the disc tray. Doing so may cause the unit to
malfunction.
• In many instances, a menu screen will appear after playback of a movie iscompleted. Prolonged display of an on-screen
menu may damage your television set, permanently etching that image onto its screen. To avoid this, be sure to press the
STOP button on your remote control once the movie is completed.
• During the DVD playback if you change the operating mode from DVD to TV/VCR, the DVD will change to the still mode. If
the user is in the TVNCR mode for more than 5 minutes, DVD will change to "resuming" stop mode automatically.