Toshiba MW20FM1 - Timer Recording

recording
Timer recording can be programmed on-screen with the remote control.
The built-in timer allows automatic unattended recording of up to 8
programs within 1 month.
TV/VCR
2-3, 5
6
1
1-3,5
CANCEL
Timer recording
Preparation:
• Press TV/VCR to select the TV/VCR mode.
• Load a cassette tape withthe erase preventiontab
intact.
• Check the time and date are correct[_.
Example:
Programa timer recordingfor 23rdday, channel 125
(CATV), 7:00 - 9:30 PM (Tape speed : SLP).
1
Press MENU. Press t or _ to select "TIMER
REC SET", then press ENTER.
|
|
MENU _ | _SET-_
/ I AUTO REPEAT ONI'OFF t
[ =S_S_M_-U_ .......]
,,,u.
%1111 ,
_2 ress t or # to select one of the program line,
then press ENTER.
Press t or _ to select the date, then press
ENTER. r TP_ERREcSET
/ START 8:30A_ I
END ,_: ;*
/ eH 0_ • |
/ S_EO SP /
L (_i_EWCANCEL/MENU) J
Set the start time, end time, channel and tape
speed as in step 3.
Notes:
]
• Press CANCEL to move cursor backward for correction.
• To record from external source set the channel to "L1" or
"L2". "Lt" or "L2" will appear next to CH 125 (or 69).
To set the timer for another program, press
or _ until the number of the second program
blinks, then press ENTER. Repeat steps 2 to 4
to set the second program.
L:i:;; i
6
Press both TIMER REC at the same time.The
TIMER REC indicator will light.The Timer is
programed, when the programed time is
reached, the recording is automatically
started.
-- _"-- T_ME__ECTO cancel timer recording, press both
do
the buttons again and TIMER REC
" ' \ indicator will go out.
Notes:
• The VCR section cannot be used while the TIMER REC
indicator is lit, If you want to use the VCR operation,
press both TIMER REC buttons at the same time to deactivate
the timer.
• When the clock is not set, you cannot select "TIMER REC".
In this case, set the clock (see page 20-22).
• After a power failure or disconnection of the power plug,
all programmed recording setting and time display will be
lost upon resumption of power. In this case, reset the clock
(see pages 20-22) and reprogram any timer recordings.
• If you want to correct the digits while setting, press
the CANCEL button until the item you want to correct, then
press t or ! to correct the desired setting.
• If programming is performed without a tape in the unit, or
with a tape without an erase prevention tab, the Timer
Recording is not possible. If a tape without an erase
prevention tab is in the unit, the tape will be ejected.
..rl
O
A
<
(_