Warning:
• When you are connecting (via the BITSTREAM/PCM AUDIO OUT jack) an AV decoder that does not have Dolby Digital,
Digital Theater Systems (DTS) or MPEG2 decoding function, be sure to set "Audio Out Select" to "PCM" from the on-
screen displays [_[_. Otherwise, high volume sound may damage your hearing as well as the speakers.
• When playing DTS-encoded discs (unit), excessive noise may be output from the analog stereo jacks. To avoid possible
damage to the audio system, you should take proper precautions when the ANALOG AUDIO OUT (L/R) jacks of the unit
are connected to an amplification system. To enjoy DTS Digital Surround TM playback, an external 5.1 channel DTS Digital
Surround TM decoder system must be connected to the BITSTREAM/PCM AUDIO OUT jack of the unit.
k J
MPEG2 sound
You can enjoy motion picture and live concert DVD video discs with dynamic
realistic sound by connecting an amplifier equipped with an MPEG2 audio decoder
or MPEG2 audio processor.
Amplifier equipped with an I
MPEG2 audio decoder I
I
/_ ToCOAXlA'-L-" [LJI _ '°1 IJI
[_ W type digital
/ audiOinput
_75 , coaxial cable J
• Use DVD video discs encoded via
the MPEG2 recording system.
• Make the following setting.
On-screen display Select: Page
"Audio Out Select.... Bitstream" [_
Recording system MPEG [_
Connecting to an amplifier equipped with a digital audio input ............ 1
2 channel digital stereo
Youcan enjoythe dynamic soundof 2 channel digitalstereo by connectingan amplifier
equipped witha digitalaudio inputand speaker system (rightand leftfront speakers).
,_-_F- Amplifier equipped with _1 _ " Make the following setting.
_P' I I adigita'audioinput I _1 _ .o_ On-screen display Select: Page
I_ _ _ TOCOAXIAL ? [_V type digital j. "Audio Out Select.... PCM" [_
/ audioinput
_ 75 £2coaxial cable I
Notes:
• DO NOT connect the BITSTREAM/PCM AUDIO OUT jack of the unit to the AC-3 RF input of a Dolby Digital Receiver. This
input on your AN Receiver is reserved for Laserdisc use only and is incompatible with the BITSTREAM/PCM AUDIO OUT
jack of the unit.
• Connect the BITSTREAM/PCM AUDIO OUT jack of the unit to the "COAXIAU' input of a Receiver or Processor.
• Refer to the owner's manual of the connected equipment as well.
• When you connect the unit to other equipment, be sure to turn off the power and unplug all of the equipment from the wall
outlet before making any connections.
• The output sound of the unit has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate listening level.
Otherwise, the speakers may be damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the unit's power cord. If you leave the amplifier power on, the
speakers may be damaged.
18
To Next Page
Loading...
