,"_!_ !@__!_!!!_!!_!@!!!!_ii!Mi!!!!_i!!_!_!_!_i!!_!_!_!i!___i_:_i!_i!!!ii_i!!i_i;i!!!_!_i_!_!_N!!i_i_@!i!_!!!i_!_!!iii_!_!_!_ili_!i!!i_!i!i_!_!!i!!_i_!i{_ii!_!_!_!!!_!i!_il!_!i!!_!!_!_!_i_!iii_!!_l_:!_!i!_!i;__!_ii{_:!_!i!_!_!i_!__i!_!!!ii!!_i!_i_!i_!_;_i_!!!ii!_i;!:__:!!i_l_i__;i!_i !i!__!iii!!¸¸_!!_!_!_!_!_!i_@t_!ii!_!!i_?!_i!_!i__ii_!_ii_!_!i_!_!!i!_ii!!ii;;__!_!_i_i!!m!_!!!i!!_i!!_!!!i_i!_!_!_iiii_!!i_!!!i_!_!_i_!__!_!_i_!:
ner setting
This unit is equipped with a channel memory feature which allows
channels to skip up or down to the next channel set into memory,
skipping over unwanted channels. Before selecting channels, they must
be programmed into the unit's memory. In addition to normal VHF and
UHF channels, this unit can receive up to 113 Cable TV channels. To
use this unit with an antenna, set the TV/CATV menu option to the TV
mode. When shipped from the factory, this menu option is in the CATV
mode.
i_ tl
1,4
1,3
1-3
TV/CATV selection ............
/f ]
Setting channels automatically
Preparation:
• Press TV/VCR to select the TV/VCR mode.
Press MENU. Press t or | to select"CH SET-
UP", then press ENTER.
MENU
SETUP f ._._
|
[-I _ET-UP ]
I tlI\A_OREPEAT ON'OFF |
l, s_st_sF_ l
{_/ENTEP_MENU)
t ,
Press t or | to select "TV/CATV".
( \ ,OH $_T-uP..... "_
/"1 _'TVOAIV .... |
l ,'1_ _
1
Press MENU. Press t or _ to select"CH SET-
UP", then press ENTER.
Press ENTER to select the "TV" or "CATV".
The arrow indicates the se-
lected mode.
I -I _CATV ...... /
[ _AUTOCHMEMe_Y I
/
Press MENU repeatedly until the menu screen
is cleared.
MENU
SETUP
MENU
I" u:
SETUP / I TIMER_;_ /
/ /
........... I -I CH _T-gP |
I _I_AUTOR_P_T l
........................... / |
J
Press t or ! to select"AUTO CH MEMORY".
I -.1_AUTO CH _-MORY /
t
J
Then press ENTER.
The unitwill begin memorizing all the
channels available inyour area.
Channel numberswillremain red until
auto memorizingiscomplete.
Press MENU repeatedly until the MENU screen
is cleared.
MENU
SETUP
Notes:
• If a station being viewed stops broadcasting, the TV will
automatically shut itself off after 15 minutes.
• You can't select "CH SET-UP" if you set the channel to
"LINE1" or "LINE2".
126
To Next Page
Loading...
