g a video tape
If you connect the unit to another VCR or Camcorder, you can duplicate a
previously recorded tape. Make all connections before turning on the power.
: i TVNCR
i
_ 3
i!i i
2
Preparation:
• Press TV/VCR to select the TV/VCR mode.
• Load a cassette tape with the erase prevention tab
intact.
• Load a previously recorded tape into the playback
VCR or Camcorder.
Press SP/SLP to select the desired tape speed
SP or SLP,
SP/SLP
CD
RETURN
It is recommended that you set the
Speed to the SP mode on the
recording VCR for best results.
Press INPUT SELECT once or twice to select
AUDIO/VIDEO input position.
"LINE2" will appear on the screen.
,. UT [ ]
SELECT UNE2
CD
LINE] : on the rear panel
I_INE2: on the front panel
Press both REC at the same time, then press
PAUSE/STILL,
oREC "--_ -PAUSE/STILL
c:) QD
Press PLAY on the playback VCR, then press
PAUSE!STILL
Release the recording pause and the playback,
Note:
Unauthorized recordingof copyrighted television programs, films,
video cassettes and other materials may infringe the rights of
copyright owners and be contrary to copyright laws.
Connection with second video recorder
Playback VCR
O
@ O
I I I
" TOVIDEO OUt_l_ I_ TOAUDIO (R) OUt
AUDIO/VIDEOCable (supplied) T \T° AUDIO (L)OUT
RecordingVCR
i
I
III
ToWD_O_ 4_L--- 1-oAUDIO<R)_
"1"" - To AUDIO (L) IN
Connection with Camcorder
Playback Camcorder
RecordingVCR -----.-.I_ L_._a..c k
.....
ToAUDIO (R) IN
AUDIO (L) IN
ToVIDEO IN AUDIO/VIDEO Cable (notsupplied)
For duplicating a previously recorded tape from a
camcorder, follow the camcorder manufacturer's
instructions. A typical camcorder dubbing hookup is
shown above.
146
To Next Page
Loading...
