Toshiba MW20FN1/R - Preparation

a video tape
If you sonnect the unit to another VCR or Camcorder, you can
clap}bate a previously recorded tape. Make aII connectkms befora
tumi_g on the power.
TV/VCR
®
il
iI
, 3
_Preparation:
•Press TV/VCR to select theT'V/VCR mode.
• Loada cassette tape withthe erase prevention tab
intact.
• Load a previously recorded tape intothe playback
VCR or Camcorder.
Press SP/SLP to select the desired tape speed
SP or SLP,
SP/SLP
RETURN
It is recommended that you set the
Speed to the SP mode on the
recording VCR for best results.
2 Press iNPUT SELECT once or twice to select
AUDIO/VIDEO input position.
"LINE1" or "LINE2" will appear onthe
INPUT screen.
S_LECT
zO0_
LiNEr: on the rear panel
LINE2: on the _ront panel
Press both REC at the same time, then press
PAUSE/STILL
FORE C _ *PASSFJ_T&L
Press PLAY on the playback VCR, then press
PAUSE/STILL
Release the recording pause and the playback,
Note:
Unauthorized recording of oopydghted television programs, _rns,
video cassettes and other materials may infringe the rights of
copyright owners and be contrary to copyright laws.
Connection with second video recorder
• Select "LINE1" on step 2
PlaybackVCR
ToWDEOOUT _ TOAUDIO_a_OUT
[
Audi°/Vidg°£_'ble(n°_'_appl_ed_T _TOAUDLO(L) OUT
Recording VCE
-- To VIDEO Itx
To AUDIO (L) IN
_'To AUDIO (R) _N
Connection with Camoorder
• Select "LINE2" on step 2,
PlaybackCamcorder
To AV Jack
Illustration of
MW2OFN1/R
For duplicating a previously recorded tape from a
camcorder, follow the camcorder manufacturer's
instructions. A typical cameorder dubbing hookup is
shown above.
0
471