Toshiba nv-pack Series - Operation Mode Setting Switch (MODE)

3.1 Switch Setting
Unified Controller nv-pack series TC-net 100(JTNI)Extended card Instruction Manual
13
3.1.2 Operation mode setting switch (MODE)
The operation mode setting switches are 4-bit dip switches.
Normal operation use switch set to all OFF.
Table 3-2 shows the descriptions of the switches.
Table 3-2 Operation mode setting table
Switch
number
Name Function Setting
Initial setting
(factory
setting)
1 RV1 Reserved Not used off
2
RV2
Reserved
Not used
off
3 SYN Syn-node
Set off/on
Set to syn-node setting as enable.
Off: disable On: enable
off
4
RV3
Reserved
Not used
off