Toshiba nv-pack Series - Setting the Scan Talker Blocks

3.3 Setting with the Engineering Tool
Unified Controller nv-pack series TC-net 100(JTNI)Extended card Instruction Manual
29
3.3.2 Setting the scan talker blocks
Set the scan talker blocks from the product tree.
Select the [Talker blocks] of the TC-net 100LAN, and then select [Talker
Blocks] from the menu bar.
Figure 3-17 Scan talker blocks reading screen
Register each of the blocks.
Register each of the blocks.
Figure 3-18 scan talker blocks setting screen
Block No.: Indicates the scan sending block number.
Word No.: Specify the starting word number used in the block.