Toshiba nv-pack Series - Referring to Information by Socket

Chapter 7 Application Interface
6F8C1621
56
The base address of the station bus address varies depending on the slot where
the JTNI is installed. The following table shows the starting word addresses of
the information by socket when the JTNI is installed to different slots.
Table 7-2 Slots and station bus addresses
Base address
(CntBase)
Beginning of single
Ethernet information
by socket
Symbol name on the
engineering tool
Slot 50
52428800
%MW13.52559744
TC_SOCKET_50
Slot 53
55574528
%MW13.55705472
TC_SOCKET_53
7.1.2 Referring to information by socket
As described in "7.1.1 Configuration of information by single Ethernet socket,"
information by socket used by each of the user applications is expanded on the
station bus of the JTNI. There are some considerations when accessing the
information.
When socket communication is performed using an instruction word by the
controller, the socket number is obtained from the instruction word using the
USEND_N command. The socket number is managed by the controller. The
socket number is once converted to a socket ID managed by the JTNI. Based
on the converted socket ID, the information by socket is referred to that is
expanded on the station bus of the JTNI.
For detailed explanation of the communication FB, refer to "Unified Controller
nv series/Integrated Controller V series Command Manual" (6F8C1226).