Chapter 3 Setting
6F8C1621
Setting the module parameter.
Open the module parameter screen for the JTNI previously registered, then
setting tab of [Parameter].
Figure 3-8 Module parameter registration screen
Register the IP address type, IP address, and subnet mask.
Note
•
Be careful so that the address does not overlap with other nodes.
Individual settings are as follows.
· IP address type: Select from V Standard 1, V Standard 2, and Any.
Case as V Standard 1 sets.
IP address: 172.16.64.xx ("xx" indicates the value of the station address
setting switch.)
Subnet mask: 255.255.192.0
To Next Page
Loading...
