Chapter 4 Operation
6F8C1621
The switches of the product have been adjusted for the system at the site
adjustment. For normal operation, do not change any switch other than the
ones the customer is required to operate.
CAUTION
The product does not operate normally if the switches
are set incorrectly. Read this operation manual
thoroughly to avoid incorrect setting.
Prohibited
CAUTION
Stop using immediately when an error occurs.
When an error occurs such as unable to turn on the
power, stop using and contact one of Toshiba's service
representatives.
Mandatory
Checking before operation
Before turning on the power and operating the product, check again that the
following are as described in this operation manual:
• Switch setting
• Installation
• Wiring
•
Checking the switch settings
Use the engineering tool to check the switch settings (station address setting switch and
operation mode setting switch).
Startup operation
When the power supply is turned on, the unit starts running automatically.
When the JTNI is up and running, check that it is operating correctly by
referring to "Table 1-1 Display details on the state display LED and normal
display" on page 5.
If the module doesn't start up or if the operation is erroneous, stop using the
product immediately and contact one of Toshiba's service representatives.
Shutdown operation
Operate shut down, then turn off from the power off.
To Next Page
Loading...
