4.7 Base assembly 4 Replacement Procedures
PORTÉGÉ A600 Maintenance Manual (960-710) [CONFIDENTIAL] 4-19
Installing the Base assembly
To install the base assembly, follow the steps below and refer to Figure 4-7.
1. Set the base assembly to the cover assembly.
2. Secure the base assembly and cover assembly with the following screws.
• M2×4C BIND screw ×1 (Described as “A” in the Figure 4-7)
• M2×6C BIND screw ×15 (Described as “B” in the Figure 4-7)
• M2.5×10C FLAT HEAD screw ×2 (Described as “C” in the Figure 4-7)
To Next Page
Loading...
