4 Replacement Procedures 4.13 3G card
4.13 3G card
Removing the 3G card
To remove the 3G card, follow the steps below and refer to Figure 4-17.
1. Disconnect two 3G antenna cables from the connectors on the 3G card.
2. Remove the following screws and disconnect the 3G card from the connector on the
3G FPC.
• M2×3B S-THIN HEAD screw ×2
3. Disconnect the 3G FPC from the connector CN2750 on the system board.
4. Remove the following screws and 3G FPC.
• M2×4C BIND screw ×3
M2×3B S-THIN HEAD
3G card
3G FPC
3G antenna
Cable (blue)
CN2750
M2×4C BIND
3G antenna
Cable (red)
Figure 4-17 Removing the 3G card
4-32 [CONFIDENTIAL] PORTÉGÉ A600 Maintenance Manual (960-710)
To Next Page
Loading...
