User’s Manual 6-19
Power and Power-Up Modes
Tablet mode
Enter your password by tapping the on-screen keyboard using the Tablet
PC Pen.
Figure 6-4 On-screen keyboard
■ The beep sounds when tapping the on-screen keyboard with the Tablet
PC Pen. An * (asterisk) is displayed after “Password =” and one
character is input for every tapping.
Power-up modes
The computer has the following power-up modes:
■ Boot: Computer shuts down without saving data. Always save your
work before you turn the computer off in boot mode.
■ Hibernation: Data in memory is saved to the hard disk drive.
■ Standby: Data is maintained in the computer’s memory.
Windows utilities
You can configure various settings associated with both Standby Mode and
Hibernation Mode within TOSHIBA Power Saver.
Hot keys
You can use hot keys Fn + F3 to enter Standby Mode and Fn + F4 to enter
Hibernation. Refer to Chapter 5, The Keyboard for details.
Register your password to the computer in the laptop mode using the
standard keyboard. Refer to TOSHIBA Password Utility, in this chapter for
the detail.
Refer also to the sections Turning on the power and Turning on the power
in Chapter 3, Getting Started.
To Next Page
Loading...
