Toshiba PORTEGE M400 - Installing the HDD Kit (Serial-ATA)

8-18 User’s Manual
Optional Devices
8. With the hard disk drive in a vertical position, lift it straight up and away
from the connector.
Figure 8-19 Removing the hard disk drive pack
Installing the HDD Kit (Serial-ATA)
To install the HDD Kit (Serial-ATA), follow the steps below.
1. Move the connector until it is vertical.
2. Hold the hard disk drive vertically with its label on the left.
3. Connect the hard disk drive to the connector.
4. With the connector connected, lower the hard disk drive down to the
storage position.
Figure 8-20 Installing the hard disk drive pack
5. Seat the cover and press down until the latches click into place.
6. Secure the cover with two screws.
7. Turn your computer over.
Plastic tab
Hard disk drive
pack
Connector
Ensure that the hard disk drive is connected to the connector in a vertical
position. If the hard disk drive is slanted and connected to the connector, it
might damage the connector.
Plastic tab
Hard disk drive
pack
Connector