User’s Manual 4-31
Operating Basics
3. If you want to lock the Ultra Slim Bay HDD Adaptor II, set the Ultra Slim
Bay lock screw in the hole for the lock position.
Figure 4-20 Inserting the Ultra Slim Bay HDD Adaptor II
Ultra Slim Bay Case
The Ultra Slim Bay DVD Super Multi (Double Layer) Drive Kit II is equipped
with an Ultra Slim Bay Case. This section explains how to remove and
install the Ultra Slim Bay DVD Super Multi (Double Layer) Drive Kit II unit.
Removing a unit
To remove the Ultra Slim Bay DVD Super Multi (Double Layer) Drive Kit II
unit from the Ultra Slim Bay Case, follow the steps as described below:
1. Slide the Ultra Slim Bay latch to the unlock position.
2. Grasp the Ultra Slim Bay DVD Super Multi (Double Layer) Drive Kit II
unit and slide it out.
1. Unlock position 3. Lock screw (Lock position)
2. Ultra Slim Bay HDD Adaptor II
Store the Ultra Slim Bay DVD Super Multi (Double Layer) Drive Kit II unit in
the Ultra Slim Bay Case when removing it from the computer or
transporting it.
Refer to Ultra Slim Bay Case section in this chapter.
To Next Page
Loading...
