48
Before you begin…
Before you can set up your Toshiba Drive for PushButton Backup you
must make sure of the following:
1) The Drive must be connected, powered on, and mounted to
your computer. If you have not yet installed the Drive, follow the
instructions in "Drive Installation & Setup."
2) The Regen application must be installed on your computer. If you
have not yet installed Regen, go to "Installing Regen" in this chapter.
When you setup PushButton Backup, you create either a Backup
Store, a Duplicate Store or a Sync Store depending on the backup
strategy that best suits your needs. Each type of store has settings
and options that you can customize.
This chapter provides separate instructions for setting up
a Backup Store, a Duplicate Store, and a Sync Store.
Setting up and using PushButton Backup
To Next Page
Loading...
