Toshiba Q9 - Page 182

172 Q9 ASD Installation and Operation Manual
My Function Percent Data 5
Program  My Function Data
This parameter is used to set the trigger threshold level of the analog signal of the
My Function Percent Data 5.
The analog signal is selected using the Input Setting number from Table 7 on pg.
190.
Direct Access Number — F922
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Frequency Data 1
Program  My Function Data
This parameter is used to set the trigger threshold level of the analog signal of the
My Function Frequency Data 1.
The analog signal is selected using the Input Setting number from Table 7 on pg.
190.
Direct Access Number — F923
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Frequency Data 2
Program  My Function Data
This parameter is used to set the trigger threshold level of the analog signal of the
My Function Frequency Data 2.
The analog signal is selected using the Input Setting number from Table 7 on pg.
190.
Direct Access Number — F924
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Frequency Data 3
Program  My Function Data
This parameter is used to set the trigger threshold level of the analog signal of the
My Function Frequency Data 1.
The analog signal is selected using the Input Setting number from Table 7 on pg.
190.
Direct Access Number — F925
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Frequency Data 4
Program  My Function Data
This parameter is used to set the trigger threshold level of the analog signal of the
My Function Frequency Data 4.
The analog signal is selected using the Input Setting number from Table 7 on pg.
190.
Direct Access Number — F926
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Frequency Data 5
Program  My Function Data
This parameter is used to set the trigger threshold level of the analog signal of the
My Function Frequency Data 5.
The analog signal is selected using the Input Setting number from Table 7 on pg.
190.
Direct Access Number — F927
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.00
Units — %
F922 F927