Not Registered
Click to delete a registered password. Before you can delete a
password, you must first enter the current password correctly.
Owner String (text box)
You can use this box to associate text with the password. After you
enter text, click Apply or OK. When the computer is started, this text
will be displayed together with the prompt asking you to enter a
password.
Supervisor Password
If you set a Supervisor Password, some functions will be restricted when a
user logs on with the User Password. To set a Supervisor Password:
Start -> All Programs -> TOSHIBA
-> Support & Recovery -> TOSHIBA
Assist -> SECURE -> Supervisor password
This utility lets you do the following:
Register or delete the Supervisor Password.
Specify restrictions for general users.
Starting the computer by password
If you have already registered a password, there is one way to start the
computer:
Enter the password manually.
The password is necessary only if the computer was shut down in boot
mode, not in Hibernation or Sleep mode.
To enter a password manually, follow the steps as detailed below:
1.
Turn on the power as described in Chapter 1, Getting Started. The
following message will appear in the screen:
Enter Password [ ]
At this point, the hotkeys FN + F1 to F4 and FN + F6 to F8
do not work.
They will function after you enter the password.
2. Enter the Password.
3. Press ENTER.
If you enter the password incorrectly three times in a row, the computer
shuts off. In this case, you must turn the computer back on to retry
password entry.
TOSHIBA DX730/DX735/Qosmio DX730 Series
User's Manual 4-15
To Next Page
Loading...
Need help?
General