Toshiba RAS-05J2KVG-TR - Air Conditioner Operation Modes; Indoor Unit Display and Remote Control; Preparation and Basic Operations; Cooling, Heating, and Fan Operations

4
5
"
!
1
2
7
8
#
3
9
6
SILENT
1
3
4
5
2
ECO / SILENT OPERATION
9
ECO OPERATION
To automatically control room temperature to save energy (Except in DRY
and FAN ONLY mode)
Note: Cooling operation : the set temperature will increase automatically 1
degree / hour for 2 hours (maximum 2 degree increase). For Heating
operation the set temperature will decrease.
SILENT OPERATION
To reduce outdoor sound level during operation (Except in DRY and FAN
ONLY mode)
Note: Though operating silently, the Heating or Cooling capacity is still
prioritized to ensure having sufficient comfort inside the room.
ECO and SILENT operation setting
Press
: Start and stop the operation.
NORMAL ECO SILENT
Note: ECO and SILENT operation symbol will appear on remote control
display.
Set the timer when the air conditioner is operating.
Setting the OFF timer
1
Press for enter OFF timer setting.
2
Press
for select desired OFF timer. (0.5 - 12 hrs)
3
Press
for set OFF timer.
4
Press
again for cancel OFF timer.
TIMER OPERATION
10
1
Press : Move the louver in
the desired vertical direction.
2
Press : Swing the air
automatically and press again to
stop.
3
For horizontal direction, adjust
manually.
Note:
● Do not move the louver manually by others.
● The louver may automation positioning by some operation mode.
AUTOMATIC OPERATION
5
To automatically select cooling, heating, or fan only operation
1. Press
: Select A.
2. Press : Set the desired temperature.
Min. 17°C, Max. 30°C
3. Press
: Select AUTO, LOW , LOW+ , MED ,
MED+
, HIGH or QUIET .
COOLING / HEATING / FAN ONLY
OPERATION
6
1. Press : Select Cool , Heat , or Fan only .
2. Press : Set the desired temperature.
Cooling and Heating : Min. 17°C, Max. 30°C
Fan Only: No temperature indication
3. Press : Select AUTO, LOW , LOW+ , MED ,
MED+
, HIGH or QUIET .
DRY OPERATION
7
For dehumidification, a moderate cooling performance is controlled
automatically.
1. Press
: Select Dry .
2. Press
: Set the desired temperature Min 17ºC, Max 30ºC.
Note: Dry mode fan speed is set to Auto only.
Hi-POWER OPERATION
8
To automatically control room temperature and airflow for faster cooling or
heating operation (except in DRY and FAN ONLY mode)
Press
: Start and stop the operation.
Note: Hi-POWER opteration symbol will appear on remote contal display.
Note: TIMER opteration symbol will appear on remote contal display.
1
Infrared signal emitter
2
Start/Stop button
3
Mode select button (MODE)
4
Temperature button (TEMP)
5
Fan speed button (FAN)
6
Swing louver button (SWING)
7
Set louver button (FIX)
8
Off timer button (OFF)
9
High power button (Hi-POWER)
!
ECO/SILENT button (ECO/SILENT)
"
Clear button (CLEAR)
#
Check button (CHECK)
REMOTE CONTROL
4
AIRFLOW DIRECTION
3
● Display brightness can be adjusted, follow procedure on ".
w Require Wireless LAN connecting adapter which available as accessory.
1
ECO (White)
2
Wi-Fi access (White) w
3
Hi-Power (White)
4
Timer (White)
5
Operation (White)
INDOOR UNIT DISPLAY
1
PREPARATION BEFORE USE
2
Preparing Filters
1. Open the air inlet grille and remove the air filters.
2. Attach the filters. (see detail in the accessory sheet).
Loading Batteries (when use wireless operation.)
1. Remove the slide cover.
2. Insert 2 new batteries (AAA type) following
the (+) and (–) positions.
Remote Control Reset
1. Remove the batteries.
2. Press
.
3. Insert the batteries.
OM_1122950209_EN.indd 4OM_1122950209_EN.indd 4 20/12/2561 BE 11:2120/12/2561 BE 11:21