To Next PageTo Next Page
Need help?Do you have a question about the Toshiba RAS-10PKVSG-E and is the answer not in the manual?
General| Type | Split System |
|---|---|
| Cooling Capacity | 2.5 kW |
| Heating Capacity | 3.2 kW |
| Refrigerant | R32 |
| Power Supply | 220-240V, 50Hz |
| Indoor Unit Dimensions (WxHxD) | 798 x 293 x 230 mm |
| Indoor Unit Weight | 9 kg |
Power supply cord must meet H07RN-F or 60245 IEC66 for public use.
Use a circuit breaker or switch with at least 3mm contact separation for disconnection.
Covers qualified personnel, electrical safety, gas hazards, overheating, and refrigerant handling.
Includes not tampering with safety guards, installation load, earthing, and wiring regulations.
Use specified R32 refrigerant, pipes, flare nuts, and tools; thickness >0.8mm.
Flare connections must be outdoors; confirm no refrigerant leakage after installation.
Installation must be reported to the local power supplier before commencement.
Guidance on protecting the unit from snow and cold, including using holding frames.
Instructions for cutting, flaring, and checking the projection margin of pipes.
Steps for tightening flare nuts using fingers, spanner, and torque wrench.
Emphasizes firm tightening due to higher R32 operating pressure to prevent leaks and damage.
Essential steps including removing moisture, tightening, evacuation, leak checks, and valve operation.
Procedure for connecting and operating a vacuum pump to remove air from the system.
Guidelines and warnings for updating existing piping for new refrigerant systems.
Lists conditions like scratches, thinness, contamination, or compressor history that prevent reuse.
