Toshiba RAS-10SAVP-ND - REMOTE CONTROLLER FUNCTIONS; Core Operation Controls; Airflow Adjustment Controls; Timer and Special Mode Controls

4
EN
REMOTE CONTROLLER AND ITS FUNCTIONS
a Infrared signal transmitter
Transmits signals to the indoor unit.
b button
Press the button to start operation. (A receiving beep is
heard.) Press the button again to stop operation. (A
receiving beep is heard.)
If no receiving sound is heard from the indoor unit, press
the button again.
c Mode select button (MODE)
Press this button to select a mode. Each time you press
the button, the modes cycle in order from A: Auto
changeover control, : COOL, : DRY, : HEAT and
back to A.
(A receiving beep is heard.)
d Temperature button ( )
.. The temperature setting is raised to 30°C.
... The temperature setting is lowered to 17°C.
(A receiving beep is heard.)
e Fan speed button (FAN)
Press this button to select the fan speed. When you select
AUTO, the fan speed is automatically adjusted according to
the room temperature. You can also manually select the
desired fan speed from five available settings.
(LOW , LOW+ , MED , MED+ ,
HIGH ) (A receiving beep is heard.)
f Auto louver button (SWING)
Press this button to swing the louver. (A receiving beep is
heard.)
Press the button again to stop the louver from swinging. (A
receiving beep is heard.) () see page 16.)
g Set louver button (FIX)
Press this button to adjust the air flow direction. (A
receiving beep is heard.) () see page 16.)
h ON timer button (ON)
Use this button to change the clock and ON timer times.
To move up the time, press of the ON button.
To move down the time, press of the ON button.
i OFF timer button (OFF)
Use this button to change the OFF timer times.
To move up the time, press of the OFF button.
To move down the time, press of the OFF button.
j Reserve button (SET)
Press this button to store the time settings. (A receiving
beep is heard.)
k Cancel button (CLR)
Press this button to cancel the ON timer and OFF timer. (A
receiving beep is heard.)
l High power button (Hi POWER)
Press this button to start high power operation. () see
page 18.)
m Memory button (MEMO)
Press this button to ready for storing the settings.
Hold down the button for 3 seconds or more to store the
setting indicated on the remote controller and until the
mark is displayed. () see page 15.)
n Automatic operation button (AUTO)
Press this button to operate the air conditioner
automatically.
(A receiving beep is heard.) () see page 18.)
o SLEEP MODE button
Press this button to start sleep mode. () see page 18.)
p MY COMFORT button
Press this button to operate the air conditioner according to
the settings stored using the MEMO button. () see
page 15.)
q PURE button (PURE)
Press this button to start the electrical air purifying
operation.
Press the button again to stop operation.
r Off timer button (OFF)
Press this button to start the OFF timer operation.
You can select the OFF timer time from among four
settings (1, 3, 5 or 9 hours).
s 8°C operation button (8°C)
Press this button to start the 8°C set temperature heating
operation. ()
see page 10.)
TEMP
ON
ON
OFF
OFF
e
n
p
m
o
r
j
i
s
a
b
q
d
c
l
g
f
k
h
A1YPGTU/CPWCNA'0HO2CIG9GFPGUFC[,CPWCT[2/