Toshiba RAS-24SA-ES2 - Indoor Unit Installation Guide

– 36 –
FILE NO. SVM-10049
8-4. Indoor Unit
8-4-1. Installation Place
• A place which provides enough spaces around the
indoor unit as shown in the diagram.
• A place where there are no obstacle near the air
inlet and outlet.
• A place which allows easy installation of the piping
to the outdoor unit.
• A place which allows the front panel to be opened.
• The indoor unit shall be installed so that the top of
the indoor unit is positioned at least 2m in height.
• Also, avoid putting anything on the top of the
indoor unit.
CAUTION
• Direct sunlight on the indoor unit wireless
receiver should be avoided.
• The microprocessor in the indoor unit should
not be too close to r-f sources.
(For details, see the owner's manual.)
<Remote control>
• Should be placed where there are no obstacles,
such as curtains, that may block the signal.
• Do not install the remote controller in a place
exposed to direct sunlight or close to a heating
source, such as a stove.
• Keep the remote controller at least 1 m away from
the nearest TV set or stereo equipment.
(This is necessary to prevent image disturbances or
noise interference.)
• The location of the remote controller should be
determined as shown below.
8-4-2. Drilling a Hole and Mounting Instal-
lation Plate
<Drilling a hole>
When install the refrigerant pipes from the rear.
1. After determining the pipe hole position on the
installation plate (
ð
) drill the pipe hole (Ø65
mm) at a slight downward slant to the outdoor
side.
NOTE :
• When drilling into a wall that contains a metal lath,
wire lath or metal plate, be sure to use a pipe hole
brim ring sold separately.
<Mounting the installation plate>
Indoor unit
(Top view)
(Side view)
Remote
controller
Remote controller
Indoor unit
Reception
range
Reception
range
Fig. 8-4-2
T
o
u
n
i
t
o
u
t
l
i
n
e
2
4
0
m
m
T
o
u
ni
t
o
u
t
l
i
n
e
3
5m
m
T
o
u
n
i
t
o
u
t
l
i
n
e
2
4
0
m
m
Offset 23mm from the right side edge is
the center of pipe hole
T
o
u
ni
t
o
u
t
l
i
n
e
1
20
m
m
0
2
3
3
5
1
2
0
1
8
0
2
4
0
Offset 85mm from the left side edge is
the center of pipe hole
1
7
0
1
7
0
50
40
8
5
1
3
2
2
3
d
i
a
.
6
5
m
m
1
7
Anchor bolt holes
Hook
Hook
Hook
Pipe hole
Pipe hole (dia. 65mm)
Installation
plate
Weight
Indoor unit
Thread
2 m or more from floor
Mounting
Screw
Fig. 8-4-1
Fig. 8-4-3
m from the right side edge is
e center of pipe hole
35 120 180 240
23mm
dia.65mm
The center of the pipe hole is above
the arrow.
Pipe hole