Toshiba RAS-B10GKVP-E - Page 104

– 104 –
11-8-3. Indoor Unit (Other Parts)
11-8-4. Outdoor Unit
No.
1
Part name
Room temp. (TA) sensor
Heat exchanger (TC) sensor
Checking procedure
Disconnect the connector and measure the resistance value with tester.
(Normal temp.)
No.
1
Part name
Compressor
(Model : DA220A2F-20L1)
Checking procedure
Measure the resistance value of each winding by using the tester.
Measure the resistance value of winding by using the tester.
Red
White Blac
k
Check conduction by using the tester.
Disconnect the connector, and measure resistance value with the tester.
(Normal temperature)
5
4
3
2
1
White
Yellow
Yellow
Yellow
Yellow
5
4
3
2
1
Refer to 11-4-1. (5).
Measure the resistance value of each winding coil by using the tester.
(Under normal temp. 25°C)
Refer to 11-4-1. (3) and (4).
2
3
Remote controller
Louver motor
MP24Z
4 Indoor fan motor
Under 20°C
Position
Yellow - Pink
Resistance value
5 to 20 kΩ
2
3
4
Outdoor fan motor
(Model : ICF-140-63-2R)
Compressor thermo.
Bimetal type
(Model : US622KXTMQO)
Outdoor temperature sensor
(TO), pipe temperature
sensor (TGa, TGb, TGc,
TGd), discharge tempera-
ture sensor (TD), suction
temperature sensor (TS),
evaporator temperature
sensor (TE),
For details, refer to Section 11-5.
Red
1 Yellow
4 Pink
5 Gray
White Black
Temperature
Sensor
TA, TC (kΩ)
10°C 20°C 25°C 30°C 40°C
20.7 12.6 10.0 7.9 4.5
Position
1 to 2
1 to 3
1 to 4
1 to 5
Resistance value
380 ± 40Ω
Position
Red - White
White - Black
Black - Red
Resistance value
0.2 ± 0.01Ω
Temperature
Sensor
TA, TC (kΩ)
TO, TE, TS (kΩ)
TGa, TGb, TGc, TGd (kΩ)
10°C 20°C 25°C 40°C 50°C
105 64 51 27 18
20.6 12.6 10.0 5.1 3.4
20.0 12.5 10.0 5.3 3.6