Hi POWER
SWING
MEMOFIX
FILTER
RESET CLOCK CHECK
ON
OFF SET CLR
1
2
3
PREPARATION AND CHECK BEFORE USE
Loading the remote controller batteries.
1 Remove the cover and insert the batteries.
2 Push the RESET button.
The clock display flashes. Adjust the clock.
Place back the cover.
Batteries
• To replace the batteries, use two new batteries (AAA type).
• In normal use, the batteries last about one year.
• Replace the batteries if there is no beep from the receiver of the
indoor unit or when the air conditioner cannot be operated using
the remote controller.
• To avoid malfunctions caused by battery leakage, remove the
batteries when not using the remote controller for over one
month.
Setting the clock
Before you start operating the air conditioner, set the clock of the
remote controller using the procedures given in this section.
The clock panel on the remote controller indicates the time regard-
less of whether the air conditioner is in use or not.
Initial setting
When batteries are inserted in the remote controller, the clock
panel indicates AM 0:00 and flashes.
1 TIMER button
Push the TIMER
button to set the current time.
Each time the TIMER button is pushed, it changes the time on
one minute basis.
When the TIMER button is held down, it changes the time on
one ten minutes basis.
2 SET
SET
button.
Push the SET
SET
button.
The current time is displayed and the clock starts.
Clock adjusting
1 CLOCK button
Push the CLOCK button.
The CLOCK display flashes.
2 TIMER button.
Push the TIMER
button to set the
current time.
Each push of the TIMER button changes
the time by one minute.
Holding down the TIMER button
changes the time by ten minutes.
3 SET
SET
button.
Push the SET
SET
button.
The current time is displayed and the clock starts.
• Slide off the cover while
pushing the sides.
• Battery replacement
Be careful not to reverse the
(+) position and the (–)
position.
MODE AUTOFA N
ECO
TIMER
To Next Page
Loading...
