Hi POWER
SWING
MEMOFIX
FILTER
RESET CLOCK CHECK
ON
OFF SET CLR
1
ADJUSTING AIR FLOW DIRECTION
• Adjust the air flow direction properly. Failure to do so could cause discomfort and cause uneven distribution of
room temperature.
• When the air conditioner stops, the louver (adjustment plate of up/down air flow direction) directs upward auto-
matically.
• In heating operation, when starting the operation/executing defrost operation or when the room temperature has
reached the required set temperature, the fan stops or the air flow is vastly reduced and the louver directs
upward.
During this time, even if the SWING button or the FIX button are pushed, the louver does not move as it directs
upward. When starting the usual heating operation which blows hot air, the louver directs towards the set air
flow direction.
Adjusting the air flow direction
The air conditioner automatically adjusts the air flow direction according to
the operating conditions when AUTO or A mode is selected.
To set a selected air flow direction
Use this function when the air conditioner is operating.
1 FIX button
Hold down or briefly push the FIX button on the remote controller to
move the louver to the desired direction.
• Change the air flow louver direction within the range that is displayed.
• In subsequent operations, the air flow is automatically set to the
direction that you set the louver using the FIX button.
In HEAT/FAN ONLY operation In COOL/DRY operation
In all modes
To automatically swing the air flow direction
Perform this function when the air conditioner is operating.
1 SWING button
Push the SWING button on the remote controller.
• To stop the function, push the SWING button.
• To change the swinging direction, push the FIX button.
• In COOL/DRY operation, the louver does not stop as it directs
downward. If stopping the louver as it directs downward during swing
operation, it stops after moving for a small duration.
CAUTION
• The FIX and SWING buttons will be disabled when the air
conditioner is not operating (including when the ON TIMER is set).
• Do not operate the air conditioner for an extended period of time
with the air flow direction set downward during the cooling or drying
operation: otherwise condensation may occur on the surface of the
air flow louver and cause water dripping.
• Do not move the air flow louver manually.
Always use the FIX button.
If you move the louver manually, it may malfunction during operation.
If the louver malfunctions, stop the air conditioner, and restart it.
• When the air conditioner is started immediately after it was
stopped, the air flow louver may not move for about 10 seconds.
In STOP mode
Louver operating range
in HEAT/FAN ONLY mode
In STOP mode
Louver operating range
in COOL/DRY mode
Louver does not direct
downward in COOL/DRY mode.
In STOP mode
Louver swing range in all
operating modes
To Next Page
Loading...
