6
AUTOA
B
AM
PM
CHK
HiPOWER
ON
OFF
˚
C
:
AM
PM
:
P
AUTO
3
84
65
1
2
97
A
OFF
PM
:
AUTO
NAMES AND FUNCTIONS OF INDICATIONS ON THE REMOTE CONTROLLER
Display
All indications, except for the clock indication, are displayed by pushing the START/STOP button.
1 Transmission mark
This transmission mark indicates when the
remote controller transmits a signal to the indoor
unit.
2 Mode display
Indicates the current operation mode.
• Heat Pump model
(AUTO : Automatic control, A : Auto changeover
control,
: Cool, : Dry, : Heat)
• Cooling Only model
(AUTO : Automatic control, A : Auto changeover
control,
: Cool, : Dry, : Fan only)
3 Temperature display
Indicates the temperature setting (17°C to 30°C).
When you set the operating mode to
:
Fan only, no temperature setting is displayed.
(for Cooling only model)
4 FAN speed display
Indicates the selected fan speed.
AUTO or one of five fan speed levels (LOW ,
LOW
+
, MED , MED
+
, HIGH )
can be displayed.
AUTO is displayed when the operating mode is
either in AUTO or
: Dry.
5 TIMER and clock display
The time set for timer operation or the clock is
displayed.
The present time is always indicated except
when in TIMER operation.
6 High power display
Indicates when the High power operation starts.
Push the Hi POWER button to start and stop the
operation.
7
P
(MEMORY) display
Flashes for 3 seconds when the MEMO button is
pushed during operation.
P
mark is displayed when the button is not
pushed for more than 3 seconds while the mark
is flashing.
Push another button to turn off the mark.
8 ECO TIMER display
Indicates when the ECO TIMER is in operation.
Each time you push the ECO button, the display
changes in sequence between 1, 3, 5, or 9h.
9 A, B change indicatior remote controller
When the remote controller switching function is
set, “B” appears on the remote controller display.
(When the remote controller setting is “A” there is
no indication in this position.)
Remote controller switching function
• If two indoor units are installed in the same
room or adjoining rooms, both units may start
and stop at the same time when the remote
controller is operated. This can be prevented
by setting the switching function so that each
indoor unit is operated only by the correspond-
ing remote controller.
• To use the remote controller switching function,
contact the air conditioner dealer or the
installation company.
Resetting of the remote controller switching
To exchange the battery while using remote
controller switching function, reset the remote
controller switching.
• Exchange the battery with a new one.
• Push the “CHECK” point and “MODE” button at
the same time, to change the remote controller
setting from “A” to “B”.
(Priority is given to “A” setting.)
• Check that the changed remote controller can
or cannot operate the indoor unit.
• In the illustration, all indications are indicated for
explanation.
During operation, only the relevant indications will
be displayed on the remote controller.
To Next Page
Loading...
