Toshiba RAS-M16UKV-E3 - Names and Functions of Indications on Remote Control

– 63 –
8-5-2. Names and functions of indications on remote control
Display
All indications, except for clock time indication, are indicated by pressing the START/STOP button.
11
11
1 Transmission mark
This transmission mark (,) indicates when the remote control transmits signals to the indoor unit.
22
22
2 Mode display
Indicates the current operation mode.
(AUTO : Automatic control, A : Auto changeover control,
: Cool,
: Dry, : Heat,
: Fan only)
33
33
3 Temperature display
Indicates the temperature setting (17°C to 30°C).
When you set the operating mode to
: Fan only, no temperature
setting is indicated.
44
44
4 Louver operation display
Indicates the louver positioning and operation.
Five selectable positions
,,,,
Automatic Swing
55
55
5 FAN speed display
Indicates the selected fan speed. AUTO or one of five fan speed levels
(LOW
, LOW
+
, MED
, MED
+
, HIGH
)
can be indicated.
Indicates AUTO when the operating mode is either AUTO or
: Dry.
66
66
6 TIMER and clock time display
The time set for timer operation or clock time is indicated.
The present time is always indicated except for TIMER operation.
77
77
7 Hi POWER display
Indicates when the Hi POWER operation starts.
Press the Hi POWER button to start and press it again to stop
the operation.
88
88
8
(MEMORY) display
Flashes for 4 seconds when the MEMO button is pressed during
operation.
mark is indicated when keeping the button depressed for more
than 4 seconds while the mark is flashing.
Press another button to turn off the mark.
99
99
9 ECO TIMER display
Indicates when the ECO TIMER is in operation.
Each time you press the ECO button, the display changes in the sequence of 1,3,5 or 9h.
• In the illustration, all indications
are indicated for explanation.
During operation, only the
relevant indications will be
indicated on the remote control.
1
3
2
8
9
6
7
5
A
B
AUTOA
4
A
B
A