■
Indoor unit
2 Part names
Horizontal louver / Vertical grille /
Air discharge
The air discharge direction can be
changed.
Air intake grille
Air is taken in through here.
Earth screw
Inside the electrical box.
Air fi lter
Filters out dust.
(Behind the air intake grille)
■
Outdoor unit (The design varies depending on the outdoor unit.
The following illustration shows an example.)
Panel
There is an earth screw, valves,
and electric parts inside.
Air intake
(Side and rear)
Fixing leg
Air discharge
Piping panel
Wiring hole
Refrigerant pipe discharge
3 Wired remote controller
Remote controller model name: RBC-ASCU1*
3.1 Component Names and Functions
When operating the button, the LCD backlight will be lightened for 15 seconds.
■
Button
1234
Operation lamp
Lights during operations.
Blinks when a check occurs or the
protective device activates.
1
ON/OFF button
Press the button to turn on the air conditioner, and press the button again to turn off the air conditioner.
2
Setting button
It is used for temperature setting in general conditions. In running mode, fan speed mode and wind direction
mode, it is used for the change of respective settings.
3
Timer off button
Set the timer off.
4
Menu button
It is used for the selection of the running mode, fan speed and wind direction.
Press of the button each time, then it will switch in the following order.
• In different modes of the indoor unit, the selection of fan speed or wind direction may be omitted.
– 7 –
13-EN 14-EN
To Next Page
Loading...
