Toshiba RAV-HM401CTP Series - Function Selection Setup (RBC-ASCU1*); Function Setup Procedure

9-1-4. Function Selection Setup
<Procedure> Perform setting while the air conditioner stops.
<RBC-ASCU1
∗
∗
∗
∗
∗
>
1 Push and hold menu button and [ ] setting button simultaneously for 10 seconds or more.
• After a while, the display flashes as shown in the figure. “ALL” is displayed as indoor unit numbers during
initial communication immediately after the power has been turned on.
2 Each time [ ] [ ] setting button is pushed, indoor unit numbers in the group control
change cyclically. Select the indoor unit to change settings for.
• The fan of the selected indoor unit runs . The indoor unit can be confirmed for which to change settings.
3,6
4,5 1 7
2,4,
5
Indoor unit No.
4 Push the menu button to make Code No. [
∗∗∗∗
∗∗∗∗
∗∗
] flash. Change Code No. [
∗∗∗∗
∗∗∗∗
∗∗
] with [ ]
[
] setting button.
5 Push the menu button to make Set data [
∗∗∗∗∗∗∗∗
∗∗∗∗∗∗∗∗
∗∗∗∗
] flash. Change Set data [
∗∗∗∗∗∗∗∗
∗∗∗∗∗∗∗∗
∗∗∗∗
] with
[
] [ ] setting button.
6 Push OFF timer button to complete the set up.
• To change other settings of the selected indoor unit, repeat from Procedure 4.
7 When all the settings have been completed, push ON/OFF button to finish the settings.
(Return to the normal mode)
“
SETTING
“ flashes and then the display content disappears and the air conditioner enters the normal stop
mode. (The remote controller is unavailable while “
SETTING
“ is flashing.)
• To change settings of another indoor unit, repeat from Procedure 1.
3 Push OFF timer button to confirm the selected indoor unit.
Set data
Code No.
- 78 -