Installation Manual
‒ 30 ‒
30-EN
11
APPLICABLE CONTROLS
• For using the wired remote controller RBC-AMS55E
½
, refer to the Owner’s Manual attached to the
wired remote controller.
REQUIREMENT
• When you use this air conditioner for the
first time, it takes approx. 5 minutes until the
remote controller becomes available after
power-on. This is normal.
<When power is turned on for the first
time after installation>
It takes approx. 5 minutes until the remote
controller becomes available.
Power
on
“SETTING”
flashes
“SETTING”
goes out
Remote
controller is
available
Approx. 5 minutes
<When power is turned on for the second
(or later) time>
It takes approx. 1 minute until the remote
controller becomes available.
Power
on
“SETTING”
flashes
“SETTING”
goes out
Remote
controller is
available
Approx. 1 minutes
• Normal settings were made when the indoor
unit was shipped from factory.
Change the indoor unit settings as required.
• Use the wired remote controller to change
the settings.
* The settings cannot be changed using
the wireless remote controller, sub remote
controller, or remote-controller less system
(for central remote controller only).
Therefore, install the wired remote
controller to change the settings.
Applicable controls setup
(settings at the site)
Remote controller model name:
RBC-ASCU1
½
Basic procedure
Be sure to stop the air conditioner before
making settings.
(Change the setup while the air conditioner is not
working.)
CAUTION
Set only the Code No. shown in the following
table: Do NOT set any other Code No.
If a Code No. not listed is set, it may not be
possible to operate the air conditioner or other
trouble with the product may result.
1
Push and hold menu button and [ ]
setting button simultaneously for
10 seconds or more.
• After a while, the display flashes as shown
in the figure. “ALL” is displayed as indoor
unit numbers during initial communication
immediately after the power has been
turned on.
Indoor unit No.
To Next Page
Loading...
