Toshiba S15 - Digital Outputs Operation; Analog Outputs Verification

© Toshiba International Corporation 2021 www.toshiba.com/tic Email: TIC-ASD@toshiba.com (855) 803-7089 13131 West Little York Road, Houston, TX
STEP A
Startup Checklist
Digital Outputs
□ Verify digital output operation
The S15 has three outputs available; two relay outputs and one digital output. Two of the outputs can have
more than one function assigned. Parameter f139 determines if both functions are required to be true to
change state or only one function is required. Refer to Section 11.7 of the S15 Instruction Manual E6582175
for more details.
Analog Outputs – Refer to S15 App Note 1.4.0 Analog Output Calibration for calibration procedure and
parameters.
□ Verify analog output operation
Terminal
Function
Parameter
Default
FM
fmsl
Output Frequency
New Function Assigned
Function
Parameters
f132
N/A
Assigned Function
Terminals FLA/FLB/FLC
(Default - Fault Status)
Function
Parameters
f130 f137
Assigned Function
Terminals RY/RC
(Default - Run Status)
Function
Parameters
f131 f138
Assigned Function
Terminals OUT/NO
(Default - Speed Reach)
10: Fault Status
4: Low-Speed Detection Signal
255: Always ON
6: Speed Reach
255: Always ON
0: Output Frequency