4.6 Expansion Memory 4 Replacement Procedures
4.6 Expansion Memory
Removing the Expansion Memory
To remove the memory module, make sure the computer is in boot mode:
1. Remove one M2.5x4 screw securing the expansion memory compartment cover.
2. Push the latches securing the memory module to the outside to release it (A). A spring
will force one end of the module up (B).
3. Grasp the module and pull it out (C).
4. Seat the cover and secure its screw.
Figure 4-8
Removing the expansion memory
CAUTION: Do not touch the connectors on the expansion memory or on the
computer. Debris on the connectors may cause memory access problems.
Detroit 20 /Detroit 20E Series Maintenance Manual [CONFIDENTIAL] 4-13
To Next Page
Loading...
