4.11 Bluetooth 4 Replacement Procedures
4.11 Bluetooth
Removing the Bluetooth module
To remove the Bluetooth module, first remove the keyboard as described in the preceding
section and then follow the steps below:
1. Disconnect the antenna wire from the antenna connector.
2. Disconnect the Bluetooth FFC.
3. Remove two black M2x3 screws securing the Bluetooth module to the chassis.
Figure 4-25
Removing the Bluetooth module
Installing the Bluetooth module
To install the Bluetooth module, follow the steps below and refer to the figures in the
preceding section.
1. Seat the Bluetooth module on the chassis, then secure it with two black M2x3 screws.
2. Connect the Bluetooth FFC to the module.
3. Connect the antenna wire to the antenna connector.
Detroit 20 /Detroit 20E Series Maintenance Manual [CONFIDENTIAL] 4-25
To Next Page
Loading...
