4.8 Optical Drive 4 Replacement Procedures
3. Remove two black M2x3 screws from the bracket plate. Remove the bracket plate.
Figure 4-16
Removing the optical drive bracket
Reassembling the Optical Drive
To reassemble an optical drive, follow the steps below and refer to the figure in the preceding
section.
1. Position the optical drive bracket plate to the rear panel of optical drive.
2. Secure the optical drive bracket plate with two black M2x3 screws.
3. Install the optical drive into the bay and use the black M2.5x3 screw to secure the optical
drive.
Detroit 20 /Detroit 20E Series Maintenance Manual [CONFIDENTIAL] 4-19
To Next Page
Loading...
