4 Replacement Procedures
4-12 Satellite A80 Series Maintenance Manual
4.5 Optical Drive Module
Removing the Optical Drive Module
To remove the optical drive module, follow the steps below:
1. Turn the computer upside down.
2. Remove one M2.5x5 screw securing the optical drive module into place.
3. Slide the optical drive module from the bay.
Figure 4-8 Removing the optical drive module
Installing the Optical Drive Module
To install a device in the optical drive module bay, follow the steps below and refer to the figure in the
preceding section.
1. Slide the device into the optical drive module bay.
2. Use one M2.5x5 screw to secure it in position.
To Next Page
Loading...
